Daily Maintenance Setps of Laser Cutting Machine

1. Check the pressure of the laser working gas and cutting gas carefully before turning on the machine every day. If the gas pressure is not enough, it should be replaced in time.
2. Check whether the X-axis zero point, Y-axis zero point, Z-axis zero point, laser preparation status and other buttons are damaged (check the indicator light).
3. Check whether the zero point, limit switch and mounting block mounting screws of the X-axis, Y-axis, and Z-axis are loose, and whether the limit switches of each axis are sensitive.
4. Check whether the circulating water level in the chiller is sufficient. If it is insufficient, it must be added in time.
5. Check for leaks in the circulating waterway of the external optical path, and you must deal with the leaks in time, otherwise it will affect the service life of the optical lens.
6. After every day cutting, check the focus lens for damage.
7. Check whether the telescopic skin cavity of the external light path is burned or damaged.
8. After the daily work is completed, timely clean up the cutting waste, clean the work site, and keep the work site neat and clean.At the same time, do a good job of cleaning the equipment to ensure that all parts of the equipment are clean and free of dirt, and no debris can be placed on each part of the equipment.
9. After the daily work is completed, open the drain valve of the air tank at the bottom of the air compressor to drain water. After the waste water is drained, close the drain valve.
10. After the daily work is completed, shut down according to the shutdown procedure, and then turn off the main power supply of the entire machine.

Weekly Maintenance Setps of Laser Cutting Machine

1. Regularly clean up the debris in the air outlet to ensure the ventilation effect.
2. Regularly check the filters in the gas path to remove water and debris in the filters in a timely manner.
3. Regularly check whether the screws of the travel switch bracket and the bumper bracket are loose.
4. Clean up the dust on the filter screen of the electric control cabinet ventilation fan in time to ensure good ventilation to facilitate the heat dissipation of the internal electrical components.
5. Clean up the sundries in the protective skin cavity of the guide rail in time, so as not to damage the guide rail, thereby prolonging the service life of the guide rail.
6. After the machine tool is installedanda period of use, the level of the machine tool should be readjusted to ensure the cutting accuracy of the machine tool.
7. The lubrication filling situationof X, Y, Z axis guides and their lead screws must be checked every other week to keep the moving parts lubricated. This can extend the service life of X, Y, Z axis guides and their lead screws.
8. Check the pollution of the surface of the reflector and focusing lens irregularly (at least once a month) depending on the environment of the workshop, and clean the optical lens in time to ensure its service life.